#Alium for tanning cow hides skin

This study aims to evaluate the quality of chamois leather from rabbit skin tanned with corn oil. However, it makes the chamois leather product have a strong odor. The usual tanning material for chamois leather is fish oil. A fine grooming comb may then be used to dress the fur.One of the main characteristics of chamois leather is its high ability to absorb water thus, chamois leather is generally used for cleaning and drying. Comb the fur against the grain with a coarse fur grooming comb (available online) to fluff the hair up. Once the hide is softened to the desired degree, the tanning process is over.ġ1) The hide may be trimmed to make it more symmetrical. Sanding with coarse sandpaper should be done in conjunction with breaking the hide. A chair with a ball on each side of the back rest is preferred.ġ0) The hide should be broken every day for three or four days. When drying is well-progressed, break the hide to soften it by pulling it across a firm edge, such as a chair back. Spread it evenly and rub it in with gloved hands.ĩ) Set the hide aside, fur side down, in a protected environment overnight or until the hide begins to dry. Warming the formula in warm water makes it more fluid. Drizzle Deer Hunter’s & Trapper’s Formula over the hide, including the tail. Use scissors to open the front leg holes so the hide will lie flat. Spread the hide on a working surface, hair side down. Allow the hide to soak for 10 minutes.Ĩ) Remove the hide from the solution, wash it again and knead the water from it. Wash it thoroughly with water, and put it in a neutralizing solution made up of 1 tablespoon of baking soda per gallon of water. The pickle must be kept above 55 degrees.ħ) The hide may be removed at 48 hours (72 hours for deer, otters and other thick-skinned animals). Check the pH the next day to be sure it is lower than 2. Spread the hide to make sure it isn’t stuck together anywhere, and add it to the pickle. Apply soap to both sides of the hide, work it in and then rinse thoroughly under running water to remove all soap.ĥ) Hold the hide by the nose and squeeze out as much water as possible with the other hand, moving downward.Ħ) Move the pickle into a plastic bucket. Use a small pair of scissors to trim any meat and fat from around the nose, eyes and ears.Ĥ) Wash the hide with generous amounts of dish-washing liquid and water to remove any dirt, blood and debris. Start at the nose and work toward the tail, moving the wand constantly to prevent it from cutting through the hide.ģ) Untack the hide from the plywood. With a pressure washer of at least 2,200 psi and a fan nozzle in the wand, blow the fat and membranes off the inside of the skin. Check the pH with the test strips: If it is higher than 2, add more citric acid.Ģ) While the pickle is cooling, prep the hide by tacking it fur side down and spread open on a sheet of plywood set on sawhorses. Heat the water to dissolve the salt, and then turn the heat off.

Ricks buys his pH test strips online from Indigo Instruments.Īfter he skins a coon, here are the steps to a properly tanned hide:ġ) Make the pickle by adding at least 1 pound of salt and 3 ounces of citric acid per gallon of water. Citric acid can be found in the canning and jelly section of any grocery.

Items needed for pickling include salt, citric acid and pH test strips. Every hide must be “pickled” before tanning, using 1 gallon of water per hide.

Alium for tanning cow hides